Hi,
actually, it is a bit confusing. statpt interprets the hssfreq keyword and sets calchess in optinfo. From optinfo jobex decides, if an aoforce calculation is done or not.
It can be check direktly from the standard output stream, if an aoforce calculation is done or not. A message from 'force' should appear.
For hssfreq 1 it should look like this:
convgrep will be taken out of the TURBODIR directory
ridft ended normally
OPTIMIZATION CYCLE 1
rdgrad ended normally
force ended normally
statpt ended normally
ridft ended normally
OPTIMIZATION CYCLE 2
rdgrad ended normally
force ended normally
statpt ended normally
ridft ended normally
OPTIMIZATION CYCLE 3
rdgrad ended normally
force ended normally
statpt ended normally
ridft ended normally
...
Best regards,
Arnim