TURBOMOLE Users Forum
Installation and usage of TURBOMOLE => Parallel Runs => Topic started by: janwahl on September 06, 2011, 10:44:49 PM
-
Hello comunity,
i try to do some cc2/dft calculations and i just want to use the parallel version of dscf.
As far is understood the manual correct, dscf can be used with MPI.
But if i do some dscf calculation dscf is always showd as a single process ( i use top to show all processes) whereas ricc2 is used parallel (ricc2_mpi)
Do i have to set any special flag??
Best reegards
Jan Wahl
Edit: Problem has been solved. Some problems with the path