TURBOMOLE Users Forum
Forum General => TURBOMOLE Forum General => Topic started by: brijesh on October 30, 2019, 08:58:19 AM
-
Hi All,
I have located the transition state for a system using RI-MP2 method. Can I do DRC -i calculation using the RI-MP2 method?
Thanks in advance.
Best Regards,
Brijesh
-
Hi Brijesh,
yes, that is possible. You have to do the RI-MP2 calculation with the ricc2 module.
Also, a NumForce run has to be done before the DRC job.
Cheers,
Arnim
-
Thanks Arnim. I have done NumForce calculation (NumForce -ri -level mp2).
How do I run DRC -i with RI-MP2 ?
If I run :
DRC -i
I gives only SCF values.
Best Regards,
Brijesh
-
I am not sure, which version you use. But it is always better to use
NumForce -level cc2
after the
jobex -level cc2 -trans
optimization.
Prepare the input according to the manual with such keys:
$ricc2
mp2
geoopt model=mp2
Cheers,
Arnim