TURBOMOLE Modules > Riper
Is it possible to split a RT-TDDFT calculation into several sequential runs?
(1/1)
ironcevic:
Hello,
I have limited queue time for jobs, so it would be beneficial to split the time propagation in RT-TDDFT calulations across several runs. Is this possible? I tried the $restart keyword but that just reads the scf and starts the RT-TDDFT from scratch.
Best wishes,
Igor
manas.sharma:
RT-TDDFT calculations cannot be restarted and run from scratch right now. The restart feature may be added in the future.
For a faster simulation, you can try turning the SCF scheme off within the $rttddft block using scf off, which will then enable the predictor-corrector scheme.
Alternatively, you can also try using a larger time step of 0.4 or 0.5 au depending on the desired energy range of the spectrum.
Navigation
[0] Message Index
Go to full version