TURBOMOLE Modules > Mpgrad and Rimp2
jobbsse with rimp2
(1/1)
cat_1:
Hi, I am beginner of Turbomole.
could you please tell me how to calculate jobbsse with rimp2 ?
To calculate BSSE by countepoise with rimp2 on Turbomole,
Should I calculate (1) dscf , then (2) rimp2 ?
I calculated directly rimp2 with bsse. Because jobbsse has scf, not dscf. ( jobbsse -h, then found scf. not dscf.)
What I have done was as follows;
define, a coord, desy, ired, frag on, b all def2-TZVP, eht.
Then, at the command line,
jobbsse -setup
. Then ghost atoms were appeared.
So, at the jobscript,
jobbsse -ri -level -mp2 > jobex.out
.
Then the error was occurred.
---
use the command 'actual -r' to get rid of that
========================
internal module stack:
------------------------
bsseenergy
turbo_setup
========================
---
Could you please tell me how to solve this problem ?
Thank you very much in advance.
Arnim:
Hello,
which version are you using? The rimp2 module is outdated and is not shipped in recent Turbomole versions anymore. The whole RI-MP2 capabilities are included in the ricc2 module. The settings can be done in the cc sub-menu of define. You should try to use that.
Cheers,
Arnim
cat_1:
Hello. Thank you very much for telling. We use Turbomole 7.3. So, you meant recent version of Turbomole isn't shipped rimp2.
So... then, if I understood correctly, first I need to use "define" then assign rimp2 from ricc. After that, I should use "jobbsse -ri -level -mp2 > jobex.out" ? If it is stupid question, I apologize.
Arnim:
If you have set up the $ricc2 keywords correctly, you can just call 'jobbsse -ricc2'.
Cheers,
Arnim
Navigation
[0] Message Index
Go to full version