$cell angs

[paapu]

Dear All,
I run serial an TURBOMOLE V7.1 ( 20389 )

I try to run jobex -riper with the following lines in control:
$periodic 3
$cell angs
17.63 17.857 17.898 90.0 90.0 90.0
$kpoints
nkpoints 1 1 1

In output there is (job.last)
       Direct space cell vectors (au):
               a     17.63000000      0.00000000      0.00000000
               b      0.00000000     17.85700000      0.00000000
               c      0.00000000      0.00000000     17.89800000



So there is problem: I tried to follow the manual and give magnitudes of the lattice vectors in Å,
but according to the output they are still in bohr.
What's going on?

Terveisin, Markus

[uwe]

Hello,

when I use your keywords, my job.last file contains:

      Direct space cell vectors (au):
               a     33.31587174      0.00000000      0.00000000
               b      0.00000000     33.74483957      0.00000000
               c      0.00000000      0.00000000     33.82231834

Do you haven another $cell line in the control file? Or are there a non-visible characters in the control file (try dos2unix control)?

I'd recommend to send your input file(s) to the Turbomole support.

Regards,

Uwe

[paapu]

Ok, Thank's. I sent the control file to support. Markus